Leo,For the console, its my bad I thought the AP was done and removed the console then I reconnect to show the AP has joined using show capwap client rcb (so I missed few lines, but hope the last command make it clear) .. sadly I didn't take print sc...
Leo, you are welcomePlease find the answers below1. I reset the AP to factory default and connect it to the access port again , this is part of the console (full console attached) Initializing ethernet port 0...Reset ethernet port 0...Reset done!et...
Leo, when you use the management VLAN you dont need option 43.I made this small lab to share the output with you: From the switch:- create access vlan (using the management VLAN) From the WLC:- create internal DHCP scope for the management VLAN- For ...
The internal server provides DHCP addresses to wireless clients, direct-connect access points, and DHCP requests that are relayed from access points. Only lightweight access points are supported
Indeed you can add static IP to the AP and enter the controller IP address but the only problem is that you need console for each AP.The commands are:debug capwap console clicapwap ap ip address <IP for the AP> <subnet>capwap ap degault-gateway <GW-I...
