Hello,
So the Catalyst 4500-X supported Private VLAN Trunk Ports for a long time. The new Catalyst 9500 series that is the direct replacement does not. Any ideas when IOS-XE Everest will get support for it?
To anyone that can help with this it would be greatly appreciated. The expressway license breakdown is a mess. After romping around the web last few hours I have a better understanding of what goes where but not completely sure.
I was hoping someon...
I am looking right now at dedicated ssl decryption appliances that will allow me to decrypt ssl stream and feed into a number of systems. Mainly a Cisco ASA with firepower module and a dedicated ips.
I am running into a problem as to how to feed the...
I am getting ready to dump the cisco cx module on a asa 5525-x for the cisco asa firepower. I been using the cx module ssl decryption in order to get sight into ssl traffic. Reading the release notes for Firesight 5.4 it seems cisco has now included ...
I am setting up the Cisco Prime Security manager. I want to integrate it with AD agent so I can do Ip to user mapping. I am finding that the AD agent is retired and now Cisco says to use Context Directory Agent. Is there any other way of integrating ...
Thank you very much for clarifying and for sharing that list! Great help. I have never seen the LIC-EXP-DSK before; the guide talks about Turn and AN licenses hopping to everyone in a cluster, I assume LIC-EXP-DSK is the same.
The licenses you see above are what I have; I am confused where they go. I am aware of the peer feature. If you look at the licensing breakdown I made you can see the issue. Did you read the post?
In that case i will have to put the decryption in front of the firewall. I have used WCCP in the past for transparent proxy purposes. It worked well enough but would rather not deal with it again.
Thanks
I am asking if its possible to redirect traffic using the service-policy to a outside SSL decryption device and then feed that back into the ASA to be checked by Firepower module.
Insisted of having to decrypt all the traffic before it hits the as...
Your response doesn’t completely make sense. I am looking at a dedicated appliance for decryption only. i do not want to use the built 6.0 sourcefire on-box decryption because it has terrible performance.
I want to know if my only option i have is...
