I have several routers and switches connected to a Cisco 2511-RJ remote access terminal server. One of the routers is a Cisco 2821 router with an Etherswitch Service Module. I am able to establish a session with the 2821 via the 2511. While in the 28...
I've got two extensions registered with callcentric.com, and the attached CME configuration is working perfectly except for one thing:
outbound calling works from all endpoints, but they all use the default extension (username 17772329287) for outbou...
So here was the problem for anyone else who might experience this:
I lied about config changes. I had added an Etherchannel, thus:
SCCP local interface = interface GigabitEthernet0/0.50 = b8be.bfbb.b7d0
became:SCCP local interface = interface interfa...
Same problem here. debug voice ccapi shows Disconnect Cause=16. All VoIP phones work great. FXS analog phones have the problem that you described. Everything was working fine for a long time. There have been no configuration changes recently. I'll re...
Initially when I tried this, the "session-timeout 1" configuration under "line 66" on the 2821 router didn't disconnect the tty session with the EtherSwitch Service Module after one minute, but now it does. I didn't reload the router or anything. I'm...
Thanks, that was what I was looking for. Here is the article that I read:
http://www.cisco.com/c/en/us/support/docs/voice/call-routing-dial-plans/42720-configuring-cor.html
I attached my new configs with class of restriction configured in case anyone...
I had the same problem too. I've completely abandoned Cisco CCP. It's just too buggy. The only way to configure Cisco routers is command line as far as I'm concerned.
