Hello,
I have set up a site-to site VPN between ASA 5585 and a cisco 881 router but the tunnel doesn't come up.
I have attached the configs for assistance in troubleshooting.
Thanks,
Benjamin.
Hi Team,
I have the below setup on a 2921 router running CME;
2 GSM gateways connected to the router's VIC FX0 ports. (072....... & 073.......)
Internal extensions start with 2001 onwards
I would like assistance on how to configure dial peers to allo...
Hi Team,
I have the below setup on a 2921 router running CME;
2 GSM gateways connected to the router's VIC FX0 ports. (072....... & 073.......)
Internal extensions start with 2001 onwards
I would like assistance on how to configure dial peers to allo...
Hi Guys,
I have a new 2504 controller that I am unable to log in to either using the CLI or GUI.
I have tried to default it but still when connected to console, it doesn't display anything.
I have attached a screenshot of the same.
Any assistance on...
Hi, I have configured SSL web and anyconnect VPN on a cisco1941 router. When trying to connect to the VPN using a remote client, I get a DNS errormessage. Kindly assist. Attached is a screenshot of the error message
Hi David,
I applied the changes marked in red and the tunnel has come up.
Router#sh run
Building configuration...
Current configuration : 2929 bytes
!
multilink bundle-name authenticated
license udi pid CISCO881-SEC-K9 sn FCZ1515C42S
!
!
!
!
...
Hi George,
See below configs
I have not yet configured the dial peers since I have limited knowledge in that topic.
!ip dhcp excluded-address 10.10.10.1 10.10.10.10ip dhcp excluded-address 192.168.1.178ip dhcp excluded-address 192.168.1.1 192.168.1.1...
I have already done this but still there's no output during the boot process.
If its bad firmware, how can I install a new firmware without access to the device?
