Hi Guys,We had an issue with one of T1 lines and switched it to a different wiring set.I noticed that the Input Errors are 0, Frame is 0 and the interface resets are 349What does that value mean?ThanksChris
Can I use object-groups in static statements?I see examples with object-groups in conduit statements but from what I know, conduits are leaving the PIX IOS and I would like use object-groups.From Cisco's Config examples:The following are two examples...
I have an issue with the NAT engine over riding static statements.IE I want to have statemens like:static (inside,public) udp 6.21.12.18 9000 192.168.1.8 9000 netmask 255.255.255.255 0 0access-list PF-ACL permit udp any eq 9000 host 192.168.1.8 eq 90...
Yes it's frame-relay. We have two T1's so I can compare one against the other for stats.I asked MCI(UUNET) about this, but I couldn't get a clear answer from them.I'm not sure if interface resets are triggered by a packet, actual physical issues, los...
If it's critical to you to know the counts and you need them cleared you can try reloaded the pix(restarting) but this will take it down for a few min while it boots.