Hi All,I have having some issues with my CISCO 877M router. It is showing high CPU utilization and the users are getting intermittent/dropping out internet.Plesae see below the "Show processes cpu" results CPU utilization for five seconds: 100%/5%; o...
Hi All,I would like to configure a Cisco 877 M router with two ISP connection. One is an ADSL service and the other is a DSL service (EFM).Basically what i would like to achieve here is to keep one of the link on standby and quickly failover when the...
Hi All,We have a small setup with Cisco router, switch and some IP Phones.I was wondering if we are able to create a NAT rule so that we can access the GUI of the IP phones from the remote network.Please advise.Much appreciate your help.Thanks,
Hi All,I have a Cisco 5350 Router and it randomly reboots itself. I see the following message in my SHOW VERSION.System returned to ROM by bus error at PC 0x39292C20, address 0x0 at 10:46:02 Tue Jun 18 2013System image file is "flash:c5350-js-mz.124-...
Hi All, I also have the same problem with 2811.Is there any particular IOS that fixes this issue. Below is my output for ver and processes Cisco IOS Software, 2800 Software (C2800NM-IPBASEK9-M), Version 12.4(24)T4, RELEASE SOFTWARE (fc2)Technical Sup...
Hi Alian,Thank you very much for the post. I have not tested this yet. Looks like all the config should be good.I was also wondering what would change if the second link is configured as Fa0/0 with IP address instead of dialer interface. Much appreci...
Thanks Paolo,Please advise which updated version will have this fixed.Currently i am usiing :Cisco IOS Software, 5350 Software (C5350-JS-M), Version 12.4(25a), RELEASE SOFTWARE (fc2)c5350-js-mz.124-25a.binCheers,