procopius1980
Level 1
Level 1
Member since ‎11-13-2012
‎02-01-2023

User Statistics

  • 73 Posts
  • 3 Solutions
  • 0 Helpful votes Given
  • 3 Helpful votes Received
Recent Badges
50 Replies
1 Accepted Solution
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

I have a site with three sets of Cisco 3850 Stacks running IOS-XE 16.12.05b.  The switches are configured for INSTALL mode, and all three stacks are configured to boot to packages.conf.  The switches are on battery backups, but the site has had about...
Hello, Can anyone point me in the right direction to determine the maximum number of STP active ports a WS-C3850-48P switch stack can handle.  Please see the output below.  The command is a little mess when pasted into this thread, but this switch ha...
I'm getting stumped by what I think should be a simple issue.  First, here's a layout of my network as prior to any changes: Cisco ASA running 9.23 Base License acting as the default gateway (10.1.10.1) for a flat network.  Authentication for remote ...
Please see the attached file for a topology of the relevant portions of this network. All but three of the APs at Building B are plugged into Cisco 3650 switches that are also acting as the WLCs.  This allows for local switching of WiFi client traffi...
I have an SRST environment at my remote sites.  My ATA's do not register back with CM after network connectivity is restored.  I have to advise my end users to power cycle the device.  I have read this discussion on the issue, but I do not have entit...
Community Statistics
Member Since ‎11-13-2012 08:28 AM
Date Last Visited ‎02-01-2023 12:18 AM
Posts 73
Total Helpful Votes Received 3
Helpful Votes From