About vidutta

vidutta · 08-17-2011

Cannot currently create files. Please verify CME configuration or wait until previous file generation is complete, and then re-issue this command.:oops: Hi All,please help me with this one. I am not able to figure this one out since last 2 days...I ...

vidutta · 12-06-2013

Hi Anju,can you state the VCS design again> i guess there should be VCS control and expressay.idealy there is a settings on on VCS under VCS configuration> dialplan> configuration. Calls to unknown IP addresses > on VCS c it should be configured a...

vidutta · 12-06-2013

Hi cpartsenidis,What you may have to do is place Sx 20 on public IP and make sure DNS entries are configured correctly on sx 20 so as to get the jabber.com domain resolved correctly.you will be able to make calls from outside to inside. ie from free...

vidutta · 12-06-2013

Hey Ali,Go to os admin on CUCM and check if you have CTS sw file in there.If you have it then copy and paste the file name in this format cmterm-CTS.1-9-6-2R-K9.P1 >>>> no extention please. under loads name on CUCM .then apply config and reset ...

vidutta · 12-05-2013

Hey Ali,Confirm> Does your touch panel gives you Red x on 5th check mark while booting ? and gives you the error message:Unable to retrieve the boot image Try below mentioned steps:Make sure > In CUCM under loads name> extention is not there. file ...

vidutta · 09-20-2013

Hey Tarun,Try this:Copy the phone book URL from Ep. paste it on browser on same network PC (try both http and https)see if you get entries on browser.also you can check if TMS is set to communicate using http or "S". somewhere in admin settings > ne...

Member Since	‎07-03-2011 06:13 PM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	12

User Statistics

User Activity

CME GIVING ERROR .. ON EXTRACTION OF TAR..

C60 Dialplan

Telepresence SX20 connecting to Cisco Jabber (Free)

TX 1310 Touch pad issue

TX 1310 Touch pad issue

Re:phonebook issue