Hi to all, a customer asked me a very strange config.
Due to constraint of the Provider, the same switch should act both as PE switch and Edge switch.
I try to make an example.
In a fabulous world we have the customer switch with a port configured as...
Hi to all, i've to put 7 2960-x switch in single stack, but i've only 50 cm. stack cable.
I know shold be best have a 3 mt cable to close the stack, but the customer didn't bought it.
I know i can make an-half stack, without closing the ring and i've...
Hi to all, i've read many times many discussion, but some of them are very old about the question.i see the page on cisco web site speaking about zx http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/gigabit-ethernet-gbic-sfp-modules...
i know sip400 is supported on VSS system since SXI4 or better on SXI4http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/release/notes/features.html#wp4786761but no info about which spa supported on VSS.Do you know if SPA POS OC48 is...
Hi to all, i need to relocate a waas appliance from one branch office belonging to one location to another branch office in another location, but i want to retain the acceleration policy configured on the specified appliance. How can i do this ?i rem...
the attenuation i gave on the post was the fiber attenuation due to lenght and fiber connection (i think), this was measured by telecom that installed the dark fiber.So with 4.3 db attenuation on the fiber, you think that with a 10db attenuator the z...
Thanks for the tips, but i need some more clarification:On the CM i don't need to change anything ? only to put the device as inactive and replaceable ?the steps should be this :1) mark on the CM the device as inactive and replaceable2) move the devi...
i already installed the correct profile file in the correct path.When i try to connect to asa, anyconnect is able to find the profile and contact tha asa. The strange thing is that seems all ok: contact the asa, negotiate ike2 , authethicate the user...
