Hi,
So for an office that is running Nutanix (1 node and 2 node offices, depends on size) why would I use Nexus say 3k over a Catalyst 9000 series. I am not even considering Nexus 9k for these offices, these are not Data Centers, just larger offi...
Hello,
I have a project I have been given...I have two separate routers which will each be peering with a different ISP. I have a registered ASN and IP address block that I will be advertising. I would like to load share between the two ISP's. I ...
Hi,
We created "new" SVI interfaces on the core switch, all static routing no dynamic routing. Switches are all Layer 2 between core and MPLS router.
CORE ---> Trunk ---> L2 Switch--->Trunk--->L2 Switch---Router
Trunks on all switches have new v...
Hi, I am just looking for an explanation to this error message. I have a HA pair of 5525's that went nuts yesterday and this error showed up over a million times in about 20 minutes. It then started working again with no intervention from me, and I ...
Hi, I am looking for a simple configuration for a dmvpn network running eigrp with two hubs on a single cloud.Do i just create two nhs entries, nhrp map entries, and two multicast entries on the spoke router tunnel interfaces? And on the hub routers...
ip address 10.209.0.10 255.255.224.0 secondary - this encompasses the entire block we are using...
ip address 10.209.7.1 255.255.255.0 - this is only vlan110 which i was using to test from
Thanks Paul, I have looked over this design guide as this was the fist place i went. however, i cannot find a configuration example for dual hub/single cloud.i see the high level design and know you can do it. but it doesnt show what the configura...
