About m-martynowski

m-martynowski · 07-30-2013

I am implementing ISE and have run into several locations that have used consumer brand 4 ports switches to connect multiple workstations on one cable. I realize there is a list of supported Cisco switches for ISE, but I was wondering if anyone has ...

m-martynowski · 06-28-2013

I have an ISE implementation going on and need a switch configuration that can fail open if the ISE (Radius) is unavailable. I have some facilities on the WAN must continue to operate if the WAN service fails. They will not have ...

m-martynowski · 01-18-2013

I have an easy question, I have a site down that is using AT&T aVPN MPLS on a T1. The carrier (my beloved AT&T provider....) claims it is a wrong LMI type. However it is set to Cisco as they specify. My question is this: If you have the wrong LMI ...

m-martynowski · 07-28-2010

I am struggling with a couple of people on designing a new campus in regards to layer 2 and spanning tree. We have an established distributino layer with dual 6509 chassis that are innerconnected with a layer 2 trunk. The access closets are dual co...

m-martynowski · 10-16-2009

I have a small office with three inbound lines on an FXO card that are overlaid on the first button of each phone in the office. If a calls goes RNOA, on the phone should i be able to see the missed call history?ephone-dn 1number 111no huntstopprefe...

m-martynowski · 07-28-2010

Thanks for your input Jon and others. Looks like it is time to create in the lab and test the overall affect of both scenarios.

m-martynowski · 07-28-2010

First off, thank you for your comments, very helpful. Unfortunately we are stuck with a layer 2 trunk between the disti switches with some vlans spanning multiple access switches. So i must deal with spanning tree in some capacity. Like i said ear...

m-martynowski · 07-28-2010

we are looking at VSS long term, unfortunately the current distribution layer is in existance with 60+ access closets on it. We had to run a layer 2 trunk between the two distribution switches due to a small number of vlans that span multiple access...

m-martynowski · 10-20-2009

Thought so, guess we upgrade the HW. Thanks for your help

m-martynowski · 10-19-2009

thanks, short term i will switch to dual-line on the ephone-dn. This is running on a 1760V, can it support CME 7.x?

Member Since	‎01-16-2004 01:24 PM
Date Last Visited	‎02-06-2021 05:52 AM
Posts	25

User Statistics

User Activity

ISE question about switches

switch configuration with ISE

Misconfigured LMI setting

Campus LAN Access-Distribution design

CME Call History with overlaid phone number config

Re: Campus LAN Access-Distribution design

Re: Campus LAN Access-Distribution design

Re: Campus LAN Access-Distribution design

Re: CME Call History with overlaid phone number config

Re: CME Call History with overlaid phone number config