Hi I have a Cisco WAP121 with an SSID with both WPA2 and WPA.I have 2 clients, one client is only WPA2 and 1 WPA only client. The WPA2 client can connect with no issue, but the WPA can't.After disabling WPA2 on SSID the WPA client can connect.There i...
HiIn a 4507 we activate the IP Base License. The evaluation period is over.The Switch is up an running. This partial output of the show versionLicense Level: ipbase Type: Default. No valid license found. Next reboot license Level: ipbaseThe output ...
HiI have a Cisco 881 router when enter show ip cache flow, I see this:SrcIf SrcIPaddress DstIf DstIPaddress Pr SrcP DstP Pkts..Fa4 M.M.M.M Local X.X.X.X 32 D090 FC43 13K..Is a large amount of packets. The...
HiI authenticate all my cisco switches and routers with AAA + NPS + ADA server runs NPS service with cisco attribute shell:priv-lvl=15 or 5, depending of AD group.But I'd like configure role based with IOS view.When I issue the enable view command, ...
HiI have a 4402-12-k9 controller and I need to upgrade to 25 APs Can I buy a 12 or 25 license upgrade to this controller?I heard that is not possible to do that, there is a Cisco paper about it.Thanks
Hi The Licenses boot command is set to IP Base, then if switch reloads it will keep this license, even if the license if a evaluation one.If I change the license boot command to license boot level lanbase the next reboot I will get the switch with la...
I used the evaluation license IP Base, that comes with the switch.The switch license is LAN Base.show license image levelsModule name Image level Priority Configured Valid license-------------------------------------------------------------...
Sorry, by mistake I click on "Correct Answer"The problem is I can switch to view contextDC1841Ro1(config)#parser view MYVIEWNo view Active! Switch to View ContextWhen I try to switch DC1841Ro1#enable viewPassword:% Authentication failedNone password...
