jwood1650
Level 1
Level 1
Member since ‎03-15-2013
‎08-18-2017

User Statistics

  • 156 Posts
  • 0 Solutions
  • 45 Helpful votes Given
  • 6 Helpful votes Received
Recent Badges
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

I am unable to receive calls to my IP phones when I dial my DIDs.  I can make calls out just fine, just not sure why I can't call in.  To test I use my cell phone to place a call to my DID (provided my flowroute) and I just get a disconnect tone a fe...
I can't seem to get my CME to route my incoming calls to my phones.  I would like to have 1001 and 1002 both ring when the telephone # is dialed.  Can you please help me figure out what is wrong?  I can call out just fine, just not able to receive an...
I just installed CME 8 on my Cisco 2821 (C2800NM-IPVOICE-M), Version 12.4(3e)Trying to load my two 7975G's but I don't seem to have the firmware in the system and the phone just sits at a blank background.  What have I done wrong? Here is my show fla...
I would like to be able to configure my IP phones to make and receive calls (outside my LAN).  What is a cheap and easy way to do this?  Add a vonage device, get a SIP trunk?  Also would I need to configure my router as a gateway and install CME on i...
Below is my Home Network layout.  I am having trouble pinging the 50.2.30.0 subnet.  I created OSPF routes and I am able to ping from HomeLAN router to BackUpHomeLAN router.  My problem is that I can not ping from my laptop connected on the 192.168.1...
Community Statistics
Member Since ‎03-15-2013 08:35 PM
Date Last Visited ‎08-18-2017 04:27 AM
Posts 156
Total Helpful Votes Received 6
Helpful Votes From