Hello All,   I have different configuration files saved in flash.  I am having issues replacing the current running-configuration file using the command configure replace flash:<name of file>.  It sometimes works but I am seeing issues were the curre...

Hello All,   Please refer to the attached block diagram: I have three 3560 switches, two configured as Layer 2 and 1 as Layer 3.  I am able to route multicast data from the Layer 2 switch to the Layer 3 switch and end device using SVI's on Port 6 (VL...

Hello, I have read that vlan 1 should now not be used as the management vlan.  So on a 3560x switch I have made an attempt to move it to another vlan. I want to keep the same IP address, just move it. From the switch to a Linux terminal I edited a co...

Hello, I have several different configuration files saved in flash. I want to be able to pick any and load it as the running-config file.I have attempted to use the command: configure replace flash:<name of file>.  I receive rollback abortion message...

Hello All,Could use some help.  I am looking at using EtherChannel to route multicast data from a source to a destiantion unit.  I wouldlike to try using L3 instead of L2 using two 3560x switches.  I have made several attempts to get data to the end ...