I've read previous discussions (i.e., "wlc 5508 multiple country codes + mesh ap") on this forum that stated Mesh APs can't be supported on a WLC set-up with more than one country code configured. If you have Outdoor APs which are set-up for local mo...

We recently upgraded our Cisco WLC 5508 from and older code 7.0 to 7.4.121.0 (as well as firmware upgrade). We have quite a few Cisco 1552E APs that aren't operating in a MESH fashion. They each have a wired uplink. They aren't located at any Branch ...

I've been trying to figure out how to delete/remove a dynamic interface in the WLC via GUI and/or CLI. Up till this point, I've only had to add them for our WLAN.According to Cisco documentation I've read, under <Controller> you just click on the blu...

I'm looking at setting up some outdoor point-to-point connections that range between 7.5 miles and 8.5 miles, and not sure if ExtendAir r5005 can meet the requirements for the range, to extend data between Cisco switches that will be extend LAN servi...