About lkumar2272

lkumar2272 · 08-19-2013

Hi,Need some help with PAT. I want to use a different public IP address for NAT from the one assigned to the "outside2" interface. Below are the configs that I have used. When I am running "Config - I" (please see below) everything is fine, i am abl...

lkumar2272 · 11-15-2018

Hi Rob, Did you enable jumbo on your switch? I am in a similar situation where I have to enable jumbo's on my 56128p pair which is the DC core. I am not sure if it has any negative impact. Would be great if you can share your experience. Thanks!

lkumar2272 · 08-19-2013

Hi, Yes, you are right and this is what I expected when ISP gave this subnet. But, it didnot work until we added this command. I might have to test it again removing the route which I added.Anyway, Good to know how its done.Thanks,Kumar

lkumar2272 · 08-19-2013

Hi, Sorry for the confusion.I meant we have a different route for the IP pool that ISP has assigned to us.route outside2 182.x.x.x 255.255.255.248 182.x.x.x(gateway) 1ISP allocated us two different subnets, 182.x.x.x/30 and 182.x.x.x/29. /29 is adver...

lkumar2272 · 08-19-2013

Hi Jouni,Thanks for your response. - Yes, I have cleared the translations. No luck with that.- A far as proxyarp is concerned, no command is configured. Earlier, I have added a manual arp entry on the ASA for the NATed IP in use, this did not work ei...

Member Since	‎08-19-2013 12:15 AM
Date Last Visited	‎11-22-2018 11:37 PM
Posts	5

User Statistics

User Activity

ASA 5510 8.2 (5) PAT issues

Re: As long as you are not doing

ASA 5510 8.2 (5) PAT issues

ASA 5510 8.2 (5) PAT issues

ASA 5510 8.2 (5) PAT issues