About Fireman1224

Fireman1224 · 08-20-2013

Hello,I'm having problems getting UPS WorldShip to connect. The program says I need to allow incoming UDP on Port 1434. I set a service to allow this, but it still doesn't connect. Any ideas on how to configure this?Thanks in advance!Sent from Cisco ...

Fireman1224 · 08-15-2013

Hello,I am new to VLANs and wanted some feedback as to how I have the router set up prior to deployment. I have 5 VLANs set up as follows:VLAN IDDescriptionInterVLAN RoutingDevice ManagementPort 1Port 2Port 3Port 41DefaultEnabledEnabledUntaggedUntag...

Fireman1224 · 08-19-2013

Trent,Thanks so much for your assistance!I only have enough cable to run one more line, that's why I used the Dlink router. I need to run the Cameras off of the router on a separate VLAN, then configure it for remote access. I don't really care about...

Fireman1224 · 08-16-2013

Thanks for the advice!I am going to set it up as described, except I am going to eliminate USDA. There was an additional router at the location, so I am going to use this as another LAN attached to the remote switch to act as the USDA VLAN. Also, we ...

Fireman1224 · 08-15-2013

Ok, using two unmanaged switches to support the office computers and an office wifi SSID, running a separate line for the camera system, running a separate line for the USDA computer, and associating the Guest VLAN only to the Guest wifi, how would y...

Member Since	‎08-15-2013 10:47 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	5

User Statistics

User Activity

RV220W and UPS WorldShip

RV220W - Setting Up VLANs Help

Re: RV220W - Setting Up VLANs Help

RV220W - Setting Up VLANs Help

RV220W - Setting Up VLANs Help