About NHCOITServices

NHCOITServices · 08-14-2013

We have an SG300 52P and a SG300 28P that we need to LAG/Trunk together, but have had a hell of a time doing it. Both switches are updated to 1.3.0.62. The 52 port switch is configured in layer 3, the 28 port switch in layer 2. All connectivity th...

NHCOITServices · 08-29-2013

I was able to get this up and running. I had an additional switch that needed to be added for capacity, and was able to spend additional time with the configuration because the expansion was not immediately needed. I noticed that the switches would...

NHCOITServices · 08-16-2013

The LAG is back up and working on native VLAN 100, but I am still not able to pass other vlan traffic from the L2 to L3 switch. The switch also took out my switchport trunk native vlan 100 configs on both switches when they were connected. After I...

NHCOITServices · 08-14-2013

I will test this on Friday.-Drew

NHCOITServices · 08-14-2013

I would, but the switches are unfortunately in production. We were trying to re-address and segment the network at the same time, but ended up rolling back the segmentation. I took out the lag and used a single connection between the switches to ge...

NHCOITServices · 08-14-2013

Thanks for the response Tom.If I have an active device on any VLAN (including 100), traffic is not passed on the devices. For instance, I had a laptop connected to the L2 switch with an IP of 10.0.0.75 connected to port 1. It could ping and access ...

Member Since	‎08-14-2013 11:06 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	6
Total Helpful Votes Received	10

User Statistics

User Activity

SG300 Port-Channel Configuration

SG300 Port-Channel Configuration

SG300 Port-Channel Configuration

SG300 Port-Channel Configuration

SG300 Port-Channel Configuration

SG300 Port-Channel Configuration