Hi guys , Im having a strange issue here:
I want to add an interface to be graphed on my cacti monitor but it is not listed on interfaces options for the device.
After debugging snmp commands I noticed that there is not any info available for this in...
After some changes on my network topoly , found the following message at console: %SW_MATM-4-MACFLAP_NOTIF: Host 7819.f7bd.e7f0 in vlan 2 is flapping between port Gi0/6 and port Po2After that system goes very slow with %22 of paquet loss.I know there...
Dear All , Next days I will perform mayor changes on my me3400 switch which concentrate 100% of my customers traffic.I need to apply many configuration lines , and I would like to have a "roll-back" plan in case the resulting config dont work as expe...
Hello , I need to link a Cisco me3400 and a juniper MX960.I need to reach each gw located on my mx960 from the devices connected to the vlans 2,3 and 4 on the cisco me3400 in layer 2, then I will route each subnet.I wonder if the lines I wrote will...
Very weird:My crypto session with ZZZ.ZZZ.ZZZ.ZZZ. apears three times .... mdz-gc-he-asr#show crypto session brief Status: A- Active, U - Up, D - Down, I - Idle, S - Standby, N - Negotiating K - No IKEivrf = (none) Peer I/F ...
I think I found what I was looking for , it is :copy startup-config running-configso , this command should revert all the changes and go back to the working config.The complete preceadure would be:1) Check that current running config is the same that...
Dear Laohoo , Im not following you .... About tftp server : Yes I can reach one from my me3400.Eventhough I don`t undestand what do you need the server for.Im only asking for the right command to get back to configuration stored in memmory (which I...
O figured out , the problem was a duplicated entry in the ACLs that each match statement was refering on the crypto maps.crypto map CRYPTO 10 ipsec-isakmp description "site to site 1" set peer XX.XX.XX.XX set transform-set trans1 match address 150c...
Dear Collin Clark , thankyou very much for your response.The link you recommend is great but I can not use it since the other end point device (ASA) doesnot support VTI model so both should stick to crypto map model.Also , I need to use NAT for a new...
