Hi All,Recently my AP failed to join the controller (AIR-CT2504-K9) after I rebooted the controller. I tried to restored factory default to reconfigure them. But it is still failed to join the controller. I'm not able to identify the issue Sysinfo: (...
I installed the new Webex version 42.5.0.22254 recently. Before I used Webex Meeting many years and did not experience any logon issue. After installed the Webex and tried to logon, it was stuck after logon with my email. I can see the spinning wheel...
I got two servers sitting on different location, the servers model/hardware are same. They may need to connect the VPN to external client with Anyconnect. I installed the Anyconnect and configured the VPN gateway's IP address. One server is able to c...
I got two servers sitting on different location, the servers model/hardware are same. They may need to connect the VPN to external client with Anyconnect. I installed the Anyconnect and configured the VPN gateway's IP address. One server is able to c...
Hi everyone, hope have a good weekend. My switch is connecting to the ISP on Gi0/1. And it's connecting downstream via FastEthernet interface only. Recently I saw there is a lot of "no buffer" and "ignored" error counter. But there is no failure by c...
I got the high alarms issue on the 10Gbase-SR, that is connecting to the FPGA.... Somehow the port was disconnected unexpectedly....# sh int e1/12 transceiver detailsEthernet1/12transceiver is presenttype is 10Gbase-SRname is CISCO-AVAGOpart number i...
