Community,I have a customer who is experiencing what appears to be a cosmetic error on their 7965s. When deploying endpoints into the field they have found that if they hard code the speed/duplex to 100/Full on the PC port of the phone they get a "P...
All,I'm having trouble getting my softphone feature inside Jabber 9.2.5 to work with my CUCM/CUPS 8.6 deployment. I have the CCMIP profile setup and user associations in place. The show connection status indicates a status of Not Connected with an ...
H323 and MGCP are signaling protocols used by the voice gateway to communicate information about activity on the PSTN connections back to CUCM for call setup.Sent from Cisco Technical Support iPad App
You may have to ellaborate a little more if I get the setup wrong...I'm assuming you have a voice gateway at the remote location and it will be connected via H.323 to the CUCM as an H.323 gateway. In this case you can just set up a dial-peer on the...
Forgot that it does see the CTI ports during setup. Sorry, it has been awhile since I set a CUE up. Worst case you can use transformations to strip down the E164 to 4 digits if not supported. Forgot to attach the link as well.http://www.cisco.com/...
The CTI ports are being connected by CUCM so I dont' think the CUE device even sees the dialed CTI number. It just sees the CTI communication from CUCM to enable the call. I don't think you'll have any issues there.I'm not sure if the actual E164 n...
