About rmcgurn

rmcgurn · 03-25-2014

Hello All, It's been a while since I've done this, but don't seem to remember having this much difficulty in the past. Trying to connect CUCM 10 to Exchange 2010 UM via direct SIP trunk. I've created the trunk, and it appears as if calls are traver...

rmcgurn · 03-15-2014

I have a WLC 4400 series and am using 1142n APs. Am planning on adding Wireless IP Phones such as 7921/7925 as well as a couple 9971's. Is it possible to have 2 WLANs, one to connect the voice endpoints to running @ 2.4GHz and another WLAN with a d...

rmcgurn · 02-23-2014

Hello All,It's been a little while since I've ealt with Cisco's Presence solution. Last time was in CUCM/CUPS 7.x train. Trying to get things setup with CUCM 10 and IM and Presence (CUPS replacement?) 10, also Jabber Windows 9.6 running on Windows ...

rmcgurn · 02-23-2014

Hello All,It's been a little while since I've ealt with Cisco's Presence solution. Last time was in CUCM/CUPS 7.x train. Trying to get things setup with CUCM 10 and IM and Presence (CUPS replacement?) 10, also Jabber Windows 9.6 running on Windows ...

rmcgurn · 11-20-2013

Hello All,I have what I'm sure is a simple question, but is frustrating me. I'd like to enable ICMP response on the outside interface of my ASA's to respond to ICMP traffic that is sent from a specific DNS address (an external monitoring service). ...

rmcgurn · 05-04-2014

For what it's worth (I know this question has been here for a long time) I've found that using port-channels with iSCSI is not as good as using MPIO setup correctly. iSCSI isn't too complicated, but certain prerequisites do have to be met in order f...

rmcgurn · 03-16-2014

Thank you for your prompt response. I only have 1 WLC, it is a 4402-50. I believe that 7.0.240 is the most current release for that model. I think anything higher I need to go to the WLC5508 (or vWLC?)Also, I wasn't aware that the 7921/25 were 5GH...

rmcgurn · 02-23-2014

Jonathan,Thanks for your prompt and detailed reply. In regards to:what I remember from CUPC/CUPC is that when a user was "off-hook" that presence status would reflect on the CUPC client, whether the user was using a softphone or tethered desk phone ...

rmcgurn · 11-27-2013

My sincere apologies for not replying sooner. I've been away and unable to respond quicker. Thank you very much for your quick answer. Looks like IP Pool is the way to go in this case. Once again, thank you.

Member Since	‎11-20-2013 11:12 AM
Date Last Visited	‎08-18-2017 04:28 AM
Posts	10
Total Helpful Votes Received	5

User Statistics

User Activity

CUCM 10 and Exchange 2010 UM SIP trunk

WLC with 2 WLANs, 1 voice @ 2.4GHz and 1 data @ 5GHz 802.11n

On-Call Presence not showing with Cisco Jabber and IM & Presence 10

Jabber 9.6 Windows not showing when users on call

Enable ICMP response on OUTSIDE interface based on DNS in ASA

For what it's worth (I know

Thank you for your prompt

Jabber 9.6 Windows not showing when users on call

Enable ICMP response on OUTSIDE interface based on DNS in ASA