Here is a example of my E1 R2 setup from Mx using a 3825 in H323 hope this helpsyou will not be needing the Telmex controller E1 0/0/0 framing NO-CRC4 ds0-group 1 timeslots 1-15,17-30 type r2-digital r2-compelled ani cas-custom 1 country telmex cat...
we have tried a simple test like that and did get some good results but we have only a 2-DS3 as our connection to the MPLS cloud which is also a bit over subscribed which is the main problem. We don't have a problem accing MQC to the remote nodes ou...
we are currently looking at adding MQC (rate limiting on IP's) to every VOIP site we have but this is going to overload our router at some point and do the same at the hub site. We currently don't have any other solutions on the table. Is it possib...