I have received notification from Security about below Cisco WPA2 vulnerability and many of cisco Access-Point are affected due to this vulnerability but they have suggested software upgradation on Cisco WLC
https://tools.cisco.com/security/center/...
I have four switches and i have configured HSRP on that ,If in one group more than one switch is active what would be impact. If i want to change group number ,it will impact entire vlan? thanks in adv. Pavan Pawar
Group key (GTK) reinstallation when processing a Wireless Network Management (WNM) Sleep Mode Response frameA vulnerability in the processing of the 802.11v (Wireless Network Management) Sleep Mode Response frames could allow an unauthenticated, adja...
Sw1: Interface Grp Prio P State Active addr Standby addr Group addr Vlan1 1 140 P Active local 10.0.48.4 10.0.48.2 (conf) Vlan3 3 140 P Active local 10.0.12.5 10.0.12....
Actaully I have four switches and running under same HSRP GroupCase 1:Switch GroupSW1 1SW2 1SW3 1SW4 1Sw1 and Sw3 are active , what will be impact if two switches active in single group.Case 2:Now I want to move ...