OK, so I'm trying to do this:http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide09186a00801d1cb5.html#1027184...with the -- 'set peer hostname.com dynamic'But the version of IOS I'm running does not support the 'dynamic' fea...

I need to drive up my latency between a link to test an applications behavior. I have multiple routers I could use (1x3825 & 3x2801). I could use traffic shaping, but that doesn't let me input a latency delay in ms between packets... Any other tho...

My question to the great NetPro community... When a router is in bridging mode, does it work independent of the layer 2 protocols?

Is there any documentation anywhere that states an ACL will not work when compress stac is turned on for a synch serial interface? Is there any way to circumvent this behavior to be able to use an ACL and compression?Kind regards in advance.

OK, so I would like to mark COS bits on some specific data so I setup PBR. The policy goes through 4 access lists of which each has one statement in it looking for a different TCP or UDP port to assign to a given precedence. When I enable this on ...