hi , I would suggest you to invoke cube on your gatekeeper so whe ou make the call from cucm the acf should have the ip of the cube/gatekeeper using the invia zone and the using a dial peer point the setup to the mcu with valid dtmf. The setup you ha...
This is to expand all 4 digit to the full DID numbers so callers can have the full DID’s as there extension and telco can still provide 4 digits to route the call. It becomes a hassle in this case where every 4 digit gets converted to 8 digits in you...
Hmm ok try 2 things. 1) Remove the dialplan pattern command under the telephony service I am suspecting the 3999 is getting changed to the full 59043999 and see if that works2) also remove the cor on this dial peer dial-peer voice 1001 voip *Nov 20 1...
The call is failing because there is no route for 135.Can you check if you get any result for sh dialplan num 135. And can you remove the corlist on the 1... dial peer to see if that fixes it.Ankur
It seems you are calling AA and then transfering to the extension. Can youpaste the following debugdeb voip ccapi defdeb ccsip messagesThnxSent from Cisco Technical Support iPad App
