Hello:We have configured EoMPLS in the topology below:CE1---PE1---P---PE2---CE2CE1 AND CE2 are Cisco catalyst 2900PE1 AND PE2 are Cisco 7200P is a Cisco 2600Everything is working properly with OSPF and LDP configured.Now we want to configure QoS: To ...
Hi, I have MPLS l2transport configured with EoMPLS, and 2 CE's with 802.1q trunk in the PE's-CE's links.The vc status is up in the MPLS core and the links CE-PE are up but the packets die in the PE.CE1-(802.1q)--PE1--P--PE2--(802.1q)-CE2 ...
Hi,We have updated our routers with IOS 12.0(28),So we configured the tunnels as above,When we measure traffic we can not limit the maxium bandwidth, we configured 64kbps max as indicated above with, tunnel MPLS traffic-eng bandwitdh 64but we have th...
Thanks for you answer.Our configuration of EoMPLS it's a little different because we didn't use the pseudo-wire class or xconnect.We based our configuration in this link:http://www.cisco.com/en/US/products/sw/iosswrel/ps1612/products_feature_guide091...
Ok I have a paper for an EoMPLS test that was made with same IOS and our currently configuration. But we cant make it work. We will try with a new IOS.ty
We change the topology, to eliminate P and use FE interfaces between PE's:CE1---PE1---PE2----CE2.It didn't workThis is the "sh vlan" command for PE1 and PE2r5#sh vlansVirtual LAN ID: 1 (IEEE 802.1Q Encapsulation) vLAN Trunk Interface: FastEthern...
Ok we will try to test with this IOS.This is a test enviroment.Just for yr knowledge EoMPLS was tested with same routers, same IOS (12.2(14)S), but without a P router and with a FE core and it worked fine. ty