I am monitoring a Cisco 877 using SNMP to get real time data throughput on the dialer interface.It seems that mib data at .1.3.6.1.2.1.2.2.1.10.16 (.iso.org.dod.internet.mgmt.mib-2.interfaces.ifTable.ifEntry.ifInOctets) is only updated after about 10...

Our offices are being upgraded from ADSL to an ADSL2+ service next week. I would to use an 877 router instead of the existing 837, however, I read on the Cisco site that whilst the 877 is ADSL2+ hardware capable, the support for ADSL2+ is not in the ...

I am trying to set up a Cisco 801 in Australia with a Telstra ISDN2 ServiceI can't get BRI Layer 2 to an active stateI have minimised the startup configuration of the 801 for testing purposes as below :-------------------------------------!isdn switc...

Hi group,I have a problem with my Cisco 837 router when using CBAC firewall featureI used Cisco's SDM to configure the device - SDM works a treat - nice piece of software - much better than CRWSThe final configuration works 100% for access from the l...

I have 3 sites - a head office (20 users) & 2 branch offices (5 users each)all sites have 512k DSL connections & Cisco 837 routersi wish to set up vpn connections between the branch offices & the head officeTraffic will only be originated at the bran...