Hi All, There was a power outage in my building and when the power resumed my Primary (Active) FW went to Secondary state and the Secondary (Standby) FW became Primary state. I have reverted back the Secondary to Primary as the initial setup and all ...
Hi All,
Need some advice.
I am new to Voice.
My company uses cisco call manager and we are moving office due to expansion in business and we hired few new staff.
Can I create a new number on cisco call manager for these new staff for them to...
Hi All,
Need some help on the below issue :
Switch WS-C3850-48P, stack of 3.
I wanted to add a MAC address to the MAC access list but messed up:
I used >> mac access-list extended Allowed-User-MAC-ACL-IN permit xxxx.xxxx.xxxx ffff.ffff.ffff any...
Hi all,
I need help on the below issue :
Assuming default BGP timers being used in a MPLS IPVPN network. How long does it take to withdraw affected routes from routing table of remote CEs if WAN BGP peer of one CE in the same VRF goes down?
Sugg...
Hi Paul,
Yes, I have fixed that but I am unable to remove the below from my ACL IN and ACL OUT :
permit any host 0000.0000.0000
When I do a no permit any host 0000.0000.0000 it doesn't remove this from the ACL.
How to remove this and what wil...
Thx so much guys.
May i know which commands to check these, i am not able to locate them.
Please share some commands to how to verify this.
Thanks so much.