About kulinski

kulinski · 05-23-2007

Hi together,i've configured dhcp-snooping and it seems to work by creating snooping-bindings but some laptops still don't get an ip addresswireshark says that there are only dhcp-requests and no offers/acks at the laptop debugging on the switch gives...

kulinski · 04-28-2007

hi together,i've a design-problem with dhcp snooping.when i've all the users connected to access-switches and routing defined on the distribution switches there is no problem because i can use the "ip dhcp relay information trusted" command on the vl...

kulinski · 12-01-2005

hi together,i'm looking for some oids and maybe someone is able to help...in fact i've got to get some system information of many devices and it would take too long me accessing every device and setting up some show commands.So i decided to use snmp....

kulinski · 10-18-2005

hi together,i've been searching severals hours in internet and at cco but what i found didn't made me satisfied.Maybe someone is able to help me with my questions...here they are.... :)the default time for pause time by annex 31b is 512 bit times - i...

kulinski · 08-18-2005

hi together,i'm trying to transfer an image file to a 2924xl using xmodem...another protocol, like tftp, can't be used caused by me deleting the old image :-(i tried to transfer the file with tera term but the upload to the switch didn't startnext ti...

kulinski · 05-30-2007

yes, for sure..but there is still the problem that laptops can't get access to the network.meanwhile i additionally configured "ip dhcp relay information trusted" not only at the physical interface(downlink to access-switch) but also at the svi at th...

kulinski · 04-28-2007

thank's for your helpthat's exactly what i was looking for :-)

kulinski · 09-13-2006

Hi,did you also try different flow control and parity setting ?i still think, that there is still a problem with your terminal settings...do you see any, if also cryptical, output at console line ?this would be a sign that someting's wrong with the s...

kulinski · 08-31-2006

Hi all,changing the use of the leds by pressing the mode button is only a temporary condition and should switch back to normal behavior after a short period of time, isn't it ?kind regardschris

kulinski · 02-24-2006

yes sure, maybe it can help somebody now..i just was a bit confused seeing that old post poppin' up again...

Member Since	‎05-05-2004 10:08 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	45
Total Helpful Votes Received	3

User Statistics

User Activity

DHCP-Snooping bridge packet get invalid mat entry

dhcp snooping

OID for bootimage and ram

Flow Control & HOL Blocking

xmodem doesn't transfer anything

Re: DHCP-Snooping bridge packet get invalid mat entry

Re: dhcp snooping

Re: No console port & no IP

Re: Cisco 3750 Problem

Re: OID for bootimage and ram