Hello, is it possible (or even necessary) to disable IPv6 on the WAN ports? I have disabled DHCP IPv6 on the LAN side by going to LAN>LAN/DHCP Setting.
Thanks.
Hello, I am replacing a Netgear fvs336gv2 router with a Cisco rv345 router. On the netgear there was a setting called "IGMP Passthrough" which I have turned on for certain reasons.
Is the "IGMP Proxy"essentially the same thing? I don't see any "IGM...
Hello, I am a small business owner.
I have recently switched to Cisco and will be installing an rv345 router. Can I delete all the "default" services listed in "Service Management". I will not be using any of these services. Is there any problem...
Hello,
I am a small business owner and am new to Cisco Small Business Routers. I recently purchased an rv345 Dual Wan Gigabit VPN Router. I have upgraded to the latest firmware. (1.0.01.17)
I have yet to install the rv345, but I will be using it...
Thanks for your help Flavio.
I see the "Multicast Passthrough" setting on many other cisco routers. But I do not see it on the rv345.
Can someone from Cisco help me out here? I am coming from using Netgear Prosafe firewalls where there is an IG...
Thanks for the reply.
Ok, Yes I see how to disable WAN2 under LAN>PORT SETTINGS at the bottom of the list.
Is there a way to disable IPV6 on the WAN1 port? I am used to being able to do this on other routers. Is this something I don't need to wo...
