About mijff

mijff · 11-17-2004

Hello,I heave a little question:How many multicast groups can a catalyst 3750 EMI switch handle when using PIM sparse?

mijff · 02-02-2004

Hi,I configured two 1710 routers for transparent bridging in a trunk (802.1q) link. The routers are connected with a tunnel, which also part of the bridge. For packets below 1468 bytes a ping between both end points works fine. A ping with bytes larg...

mijff · 01-07-2004

hi,I have two questions about pix 501 and logical interfaces (vlan's):1. is it possible for a pix 501 to create on the switch interface of the pix two VLAN's 1 for inside lan and 2 for DMZ?If so then I have 2 logical interface2. If it's possible to c...

mijff · 12-23-2003

Hello,I configured two 1710 routers for transparent bridging. The routers are connected with a tunnel, which also part of the bridge. I have tested the configuration and it works oke (see configuration below). But the routers need to be installed bet...

mijff · 05-26-2003

We have two routers. The ethernet interfaces are combined for LAN and WAN.both sides are connected via a wireless link.for back-up of the Wireless link, the isdn is used.The isdn link comes up if the route to 172.16.0.0 or 172.17.0.0 goes down, this ...

mijff · 02-04-2004

thanks for your comment,I have changed the IP MTU on the tunnel interface to 1430 bytes and even to 1400 bytes. But when I do a ping larger as 1468 bytes the pings will not be replied. Because I do a default ping in dos, the DF bit is not set. questi...

mijff · 12-24-2003

I thought that on a 802.1q link the MTU on the bridge interfaces changes of 1500 to 1524, because on a interface the MTU is max 1500 it has to be increased for the trunk.Is my theorie wrong? Why do you think, changing the MTU isn't necessary on ether...

mijff · 05-27-2003

Johan,thanks for your answer. I have changed the security issues.regards,Michiel

mijff · 08-07-2002

Thanks for your answer, here's the complete config of both routers. I did added the "class dov" in a later stadium, without the class dov, see below, it was also not possible to make a call when pinging to the dialer interface of the PRI.1 must I als...

Member Since	‎08-07-2002 11:19 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	13

User Statistics

User Activity

max multicast groups 3750 switch

GRE tunnel and MTU size

pix and vlan

802.1q over transparent bridging

isdn has gone many times up and down

Re: GRE tunnel and MTU size

Re: 802.1q over transparent bridging

Re: isdn has gone many times up and down

Re: problem dialing from BRI to PRI