About cminch

cminch · 11-18-2003

Hi,Has anyone experienced problems using the Decode Packet option on the NAM Module? It seems that even with a small capture 10 frames it doesn't load them to the gui. The only way I can get it to work is by saving the buffer to the file and downlo...

cminch · 11-18-2003

Hi,Does anyone know if there is a limit on PAT?One problem that we are having it seems that our PAT addresses are not being freed up fast enough. We have the xlate time down to about 30 minutes should we go lower?Is there a rule of thumb on somethin...

cminch · 11-18-2003

Hi,Does anyone know if you can look for dropped packets on the FWSM. I looked at CCO but did not find anything.Here is an example of what I would like to do.See any dropped packets by host 1.1.1.1.Is there also a good resource on this particular kin...

cminch · 10-01-2003

Just curious if anyone as experienced Banner's not being completed through Telnet. Had different configurations and sizes of banners. Even a simple:banner motd ^CTEST^CThis would prohibit a telnet access. This was running fine other quipment runnin...

cminch · 09-09-2002

Hello,i have been asked if there is a postive way to drop the line when it is idle. I know from the isdn side there is the idle-timer, but for DSL? By default there is a keepalive, when this is turned off the timer reset after alotted time. So we ...

cminch · 11-18-2003

You might also want to check with your IOS, as there were some limitations in some. I found this out the hard way update to the 'new and improved' IOS and the authentication no longer worked. This was for http authentication giving access to access...

cminch · 10-09-2003

Hi,Looks like this is a software error. Try checking the Network Card Driver for a newer version. Another thing make sure that the Duplex/Speed is set hard coded on boths sides. If Problems occur still, even after software update of NIC, take it d...

cminch · 09-19-2003

Hi,Do any of the switches support VLANs or Trunking? If not you might have a bit of a problem. If they do not support like 802.1q vlans you will have to physically move some of the clients around or change there ip's anyway.Regards,Corey

cminch · 09-19-2003

Hi,commands will only be valid for the exsisting module. So if you swap a different module out then you'll get the mismatches. There is an interface range command to help clear out sections or configure sections at a time. Here is a link to show yo...

cminch · 09-19-2003

Hi,What are your options for equipment? This is really a more lenghty type of a solution and you can feel free to zap me off line. One thing you should look into is VLANs this will help keep them seperate and if needed you can route in between. Bu...

Member Since	‎09-09-2002 03:19 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	63
Total Helpful Votes Received	11

User Statistics

User Activity

NAM Module decodes

PIX Limit on PAT?

FWSM Looking for Dropped packets

Banner MOTD's

Idle Time for DSL

Re: Privilege Level

Re: 2950 - input errors

Re: Network way too big

Re: clear conf and IOS on a Cat 4500

Re: What Next?