For proactive monitoring purposes, I would like to monitor a specific switch port for bandwidth usage, and alarm when it is above the threshold for x number of minutes or polls. Of course, the cheaper the better. Suggestions?
What you are trying to bring up is the new VLAN as the management VLAN. Only one VLAN can be active at one time. If you were to "shut" VLAN1, you could bring up any other VLAn as the management VLAN.From your post, I can't tell whether the VLAN the...
It sounds to me as if the 3Com response has to do with the observed throughput, not the speed setting. I have heard that due to driver overhead, you cannot get anywhere near 1000Mbps out of NT4. However, this should have nothing to do with how it i...
Without BGP, you cannot load balanc inbound traffic. However, you can load balance outbound traffic by setting up two default routes, one to each ISP router. The router will use a round-robin approach when transmitting packets. This can be done wi...
I have used this feature, and it has helped. I too had a network outage, mine due to a "developer's" platform ARPing the MSFC on the 6000 as fast as it could. The MSFC's CPU went right to 100% and the network slowed to a crawl.I set the broadcast s...