About card51short

card51short · 12-07-2017

Does anyone know why I can't get RouterA to broadcast 192.168.0.0 through RIP? I set it up on RouterB and RouterC and both those networks can ping each other but neither of them can ping RouterA's network. When I do show ip router on A, it doesn't s...

card51short · 11-25-2017

Guys I have an assignment in one of my routing/switching classes and I just cant' figure it out. I've literally redone this 4 times and I can't figure it out. I'm following all the instructions I can find to a T. What am I doing wrong ? I can pin...

card51short · 12-07-2017

I got it guys - I had RouterA's interface plugged into Gig0/1 not Gig0/0. Thanks!

card51short · 11-26-2017

OK so why did I need to do the other one on R1 and R3? can you try to explain the 0.0.0.127 quickly. I understand wild card masks just not so good at figuring them out yet.

card51short · 11-26-2017

why 0.0.0.127 for the first one? And why not on R3? If PC4 pings PC3 - won't R3 need to know the route?

card51short · 11-26-2017

OK I got it. I advertised the networks for PC2 and PC3 in R1 and R3. I'm not the best at wildcard masking so I used 0.0.0.255 and 0.0.255.255 and it works for both (since I don't need to specifically deny any other IPs) Thanks for your help!

card51short · 11-26-2017

OK yes that works. One thing though - now PC4 can't ping PC2 or PC3. Do I need to add the networks to R1 and R3's eigrp again?

Member Since	‎11-25-2017 12:14 AM
Date Last Visited	‎12-08-2017 12:45 AM
Posts	17

User Statistics

User Activity

Easy RIPv2 Question

Help with VLAN on packet tracer

Re: Easy RIPv2 Question

Re: Help with VLAN on packet tracer

Re: Help with VLAN on packet tracer

Re: Help with VLAN on packet tracer

Re: Help with VLAN on packet tracer