Hello everybody
i'm trying to enable service nagle via CLI but my SG500 returns that its an unrecognized command... Could anyone help please ?
SG500 with 1.3.0.62 firmware version.
Thanks a lot!
Hello everybody,
Please I have a SG500-52port managed switch and I'm trying to add a custom SmartPort roles and set these customs to gi1/x ports.
I've done creating custom Smartport roles but I see errors when try to attempt this to gi1/x ports a...
@Flavio Miranda
Thanks for reply! Then i can't use this switchport with port-security, right ? ( just to confirm )
I'm using this CLI guide also... About the Service Nagle... is it the same case ?
since now thank you so much
@Flavio Miranda
Another information... i'm using SG500-52port with 1.3.0 firmware... but even in 1.4.x CLI user guide, i can't found these commands like service nagle and switchports
@Flavio Miranda, yes i can select the interface gi1/X in conf t and set it to switchport mode access but after i can't set switchport mode host or switchport host
switchc04d73(config-if)#switchport mode access
switchc04d73(config-if)#switchport hos...
@Flavio Miranda,
Obrigado pelo retorno porém não funcionou, o comando retorna unrecognized command. Tem alguma outra sugestão do que pode ser ?
Obrigado!
Thanks for reply! the switchport access don't work and this command returns unrecognized com...