I'm doing a small lab. I need to make DHCP pools for VLAN's on Router1 and configure DHCP-relay agent on Router1 so PC's from VLAN 300 and 400 could recieve addresses from pools in Router0. I made the pools, but I'm really confused about configuring Router1. I rellay hope someone would help me out!
The file I attached is renamed .pkt. I'm using Packet Tracer version 6.3. Thanks for you help!
... View more
I have a problem. I'm doing a small lab for the courses. I need to create 4 DHCP pools for 4 VLAN's on Router0. And then to configure DHCP-relay agent on Router1, so PC's in VLAN 300 and 400 could recieve IP addresses from DHCP pools. That's what I've done on Router0:
ip dhcp pool 100
network 10.10.192.0 255.255.240.0
ip dhcp pool 200
network 10.10.208.0 255.255.240.0
ip dhcp pool 300
network 10.10.224.0 255.255.240.0
ip dhcp pool 400
network 10.10.240.0 255.255.240.0
encapsulation dot1Q 100
ip address 10.10.207.254 255.255.240.0
encapsulation dot1Q 200
ip address 10.10.223.254 255.255.240.0
encapsulation dot1Q 300
ip address 10.10.239.254 255.255.240.0
encapsulation dot1Q 400
ip address 10.10.255.254 255.255.240.0
I also switched Switch0 and Switch1 ports which are connected to routers to trunk mode. But I don't understand, how I should configure DHCP relay agent on Router1 and which addresses I should give to the subinterfaces on Router1. I know you can use ip helper-address on Fa0/1 subinterfaces of Router1, but I'm kinda confused about the IP addresses of all subinterfaces. I really hope someone will help me with this problem!
... View more