Clients keep getting this error as well as I. Is there something we can do to get rid of this. Nothing actually goes down, all messaging and calls work just keep getting this error every now and then.
Jabber Client: 11.9.3 Build 60004.
Can you setup incoming caller ID on an MGCP enabled gateway with an FXO port?
Not sure if this is possible. The gateway is a Cisco 2811 version 12.4.
Cisco Unified CM Administration System version: 8.6.2.22900-9
Can a UCCX call script check if a Hunt Pilot is busy? We're looking to get around buying licenses for agents in UCCX because we're out of funds until next fiscal year. Can i have a call a UCCX script check to see if a Hunt Pilot or Specific caller is...
i did everything i could find in the White Papers, spoke with Cisco TAC and after many hours i figured out the issue! The MAC Address needed to be in all CAPS in CUCM. Not sure why but Attendant Console didn't like the MAC address letters in lowercas...
i did everything i could find in the White Papers, spoke with Cisco TAC and after many hours i figured out the issue! The MAC Address needed to be in all CAPS in CUCM. Not sure why but Attendant Console didn't like the MAC address letters in lowercas...
i did everything i could find in the White Papers, spoke with Cisco TAC and after many hours i figured out the issue! The MAC Address needed to be in all CAPS in CUCM. Not sure why but Attendant Console didn't like the MAC address letters in lowercas...