Hello Seb thanks for reply. Sorry for the typo the subnets indeed are different in each site. In understand your solutions and it seems a good one, since I did diagram a simple setup for ilustrative purpouses but in the real life will be about 10 subnets per site and this setup is for varios sites (kinda mesh setup) I would like to avoid setting routes manually if possible. I was thinking if the workstations on each site use the SG300 as their default gateway and then on the mikrotik router add all the vlans interfaces with IP addresses connected to a trunk port to the cisco so all the intervlan routing happens on the SG300 and OSPF running on mikrotik publishes all the connected networks. Thanks in advance.
... View more
Good day everyone.
We currently have two sites conected thru wlan link and using OSPF between them , simple setup 1 subnet per site. we need to implement vlans on each site to have multiples network segments. I did the following diagram of the actual and the possible future setup.
My doubdt is if we introduce SG300 at each site as L3 router for intervlan, we will need to discard OSPF and go thru manual routes? is there a way the OSPF continue to work with the SG300 setup if so how could be done since in my limited knowledge the mikrotiks router would have to have ip address on each vlan to OSPF to work.
I hope to get additional help from your comments, thanks in advance.
... View more