About c.gierula

Prime Infrastructure 3.7 cli admin user · 09-30-2020

I find the Command Reference Guide for Cisco Prime Infrastructure 3.7 confusing on the topic of how can I create another admin account. With the username command, the only options are Network-Admin, Security-Admin or operator. But the the command ref...

c.gierula · 05-28-2007

I have CCM 4.0 installed and Cisco IP communicator. After starting the communicator, Cisco IP communicator displays error message: "Registration Rejected: error mismatch".

c.gierula · 11-30-2006

Hello,Two of my 3750 switches in a stack are logging a lot of stack linke changes. Is this due to a faulty cable/port? If I change the cable and it persists, what would be the next step?Thank youChris

c.gierula · 12-06-2005

Logged these two error messages:Controller port error, Interface Fa1/0/17 Power controller reports power Imax error detected.Controller port error, Interface Fa1/0/17 Power controller reports power Tstart error detected.I could not find any info on t...

c.gierula · 05-02-2005

I am working through bringing up back to back T1 PRIs for voice calls. I have the basic configurations on configuring the T1s, but when I try to forward calls and / or data (depending on the configuration) it fails. I know how to configure regular T1...

c.gierula · 10-06-2020

I wanted to change the admin password setup during the install. I found that in version 3.7 Cisco introduced a new Cli command “change-password”. Using this command, a user can change their own passwords. This command is available for all roles.note:...

c.gierula · 05-28-2007

Thanks for the help!

c.gierula · 04-18-2007

Per Cisco:make sure there is no external pressure on the cables. Cabinet enclosure might be compressing the cable.Make sure the cables are properly seated and secured.Make sure you have the right length cables.Check for proper grounding of rack/cabin...

c.gierula · 12-07-2005

Yes I saw that one. I think I might have to open a TAC to get more info. Thank you

c.gierula · 05-04-2005

This is a voice lab I am setting up so I'm using a back to back cable to simulate my T1 connection. I have since got it running, (it was a cabling problem) but now I'm trying to send voice accross, unsuccessfully.

Member Since	‎09-28-2004 09:05 AM
Date Last Visited	‎03-27-2024 12:16 AM
Posts	24

User Statistics

User Activity

Prime Infrastructure 3.7 cli admin user

IP Communicator Registration Error

Stackmgr stack link change

ILPOWER Error

Back to Back T1 PRIs for voice calls

Re: Prime Infrastructure 3.7 cli admin user

Re: IP Communicator Registration Error

Re: Stackmgr stack link change

Re: ILPOWER Error

Re: Back to Back T1 PRIs for voice calls