Hi, I tried deleting the vlan database on a 2950 switch. delete flash:/vlan.dathowever, after i reload the switch, the vlans are still there. Any ideas?Also, is there any other way of deleting the vlan database w/o reloading? apart from manually dele...
HiIs the balance method "srcip" the same as the general method known as "sticky source ip"? Whereby, the same source ip will be directed to the same destination server by the CSS?Thanks in advance.
Does anyone know how long does the arp entries remain in the arp cache of an MSFC before they get timed-out? I'm sure it's definitely not 4 min. That's the arp timeout i see when i issue a "show int vlan". But the arp entries are way longer than that...
How do i effectively get 48MB flash from a 2600XM? I know that it has a default of 16MB flash on board, plus a 32MB flash stick, I could get 48MB flash total. I added a 32MB flash stick to one of my 2600XM, it showed only 32MB flash. Whilst, another ...
Hi.. done that too. Changing the vtp mode to transparent resets the config revision to 0, but the vlan database remains in the vlan.dat file. Therefore, by deleting that file & do a reload, vlans should be cleared, but it didn't.The ios version is 12...
Hi Gilles,Thanks for getting back to me on this. So it seems to me that the preferred balance would be srcip instead of advanced-balance sticky-srcip.Since it seems that with srcip method, the CSS is smart enough to not just blindly directs to the ti...
Hi Ankur,Thanks for ur response. I understand the 3550 works in that way. But does the 3560, the newer replacements for 3550s, work the same way with the upgrade?Thanks.
Hi Rick,Thanks for the detailed explanation. Just need to clarify one more thing. So in the case when ospf is being redistributed into rip, the other rip routers connected to the redistributing router will learn of the ospf redistributed routes as ri...
