Dear All,
I configured the Cisco IPSec VPN from cisco gui in asa, however, i would like to know, how to check whether the vpn is up or not via gui for [particular customer.
I tried Monitoring-->VPN Statistics--> Session--->Filtered By---> IPSec S...
Dear All,
I recently starting to working on cisco configuration etc on switches. I have one doubt as below. Can seniors please help me to understand this?
1) Currently we did one configuration for dedicated connection between company X(My employer)...
Dear All,
I am facing the problem where my Cisco 6941 phone doesn't know anything on screen after i did the factor reset.
It is just showing Phone Not registered.
"Big Concern is that i cannot press any key on phone after this". Anyone faced this...
Dear All,
I would like to forward all the calls to my cell phone when i am not in office.
Actually currently we have scenario's like we have multiple extensions and all of them are individually configured and for all of them we configured the group...
Dear All,
I am using CME in our network and we are facing very strange issue.
When i dialed the number by using "off-hook" then Cisco Iphone is not sending the complete dialed digit to CME.
Whereas when i use "on-hook" way to dial the digit then C...
Hi Micke,You mean the table below once i click on filter tab? I can see many connection profile ip address, but i do not see the connection profile IP for the customer i configured as of now?Are you talking about that? Regads,Nitin
Hi Ryan,
Thank you very much for your reply.
However we received this VLAN ID from our customer only, because they wanted to use the same VLAN ID.
Do when both side are using "switchport mode access" is that mandatory to use same vlan id?
OR
if...
