Mike Bailey
Level 1
Level 1
Member since ‎04-11-2008
‎10-09-2017

User Statistics

  • 98 Posts
  • 1 Solutions
  • 9 Helpful votes Given
  • 4 Helpful votes Received
Recent Badges
1 Accepted Solution
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

So we're currently running LMS 3.01 which goes out of support in November/December 2012.We're also running Cisco WCS 7.0 in a completely seperate environment where we have wireless.Also please consider we have LMS fully integrated with Cisco Secure A...
According to the following:http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015c612.shtml#topic5"Only one destination port is allowed per SPAN session"however on both 2960 switch running 12.2 and 3560 switch running 15...
Hi there,Need to limit the amount of bandwidth a specific VLAN can use on a 802.1q trunk port.Situation is that we have a pair of Catalyst 4506 switches which have 802.1q trunk ports into a Checkpoint Firewall, this in turn is connected to a managed ...
Hi there,We're using the internal DHCP server on our 5500 Series WLC which works fine.However on one WLAN we ran out of addresses so changed the subnet from a /25 to a /24.The problem is that the router/gateway is still in the middle (124/125/126) an...
Hi,Don't tend to use Cisco VPN but have setup one for a development environment.This is on a PIX515E running 8.0(4), relevant sections of configuration below:aaa-server vpn protocol radiusaaa-server vpn (inside-inf) host RADIUSkey *!crypto ipsectrans...
Community Statistics
Member Since ‎04-11-2008 01:34 PM
Date Last Visited ‎10-09-2017 11:33 AM
Posts 98
Total Helpful Votes Received 4
Helpful Votes From
Helpful Votes Given To