About steve_steele

steve_steele · 04-13-2010

Hi,I'm struggling to figure out exactly what symantec software is required for HA in LMS 3.2.I've read the LMS 3.2 HA docco but the Symantec product names used do not seem to exactly match those used by Symantec.Ideally if anyone has Symantec part nu...

steve_steele · 02-02-2009

Hi guys,I'm playing with WAAS for the firsttime in a LAB environment with some test kit. I have a number of WAE-512 that seem to crash at the BIOS boot stage if I have the extra 4 port card installed. If I take the card out they run fine.I'm running ...

steve_steele · 10-01-2008

Hi Guys,I'm trying to set up a sticky configuration on an ACE modeule in a 6500.I've got the loadbalancing woking happily but need to ammend the config to add stickiness.As far as I know the first command is someting on the lines of...sticky http-coo...

steve_steele · 02-05-2009

Hi Dan, It was hardware in the end. Two of the 4 port cards were faulty. I got the replacements and it worked first time.Cheers

steve_steele · 01-02-2009

Hi The users and servers should be configured with the local 3560 VLAN interface IP address as their default gateway.If the 3G Modem is routing it will need to know how to get back to VLAN A & B. Adding routes to the 3G device directing return traffi...

steve_steele · 01-01-2009

If it's plugged into a switch that you have access to you could look in the arp table for the ip address.show arp | inc 123.123.123.123or look in the mac address table for the interface.show mac address-table interface fa0/1HTHSteve

steve_steele · 01-01-2009

Hi"ip domain name" specifies the domain name of the cisco device itself. One of the things this is used for is security certificate generation for IPSEC, SSH or HTTPS access. The certificate will be generated using the entries you put in for hostname...

steve_steele · 01-01-2009

pim nbma mode is used for multipoint nbma interfaces.pim normally maintains a database of (source / group) entries detailing which interface to send multicast traffic out of. If your frame relay connection is point to point then specifying which inte...

Member Since	‎01-05-2005 02:58 AM
Date Last Visited	‎09-05-2018 12:26 AM
Posts	114
Total Helpful Votes Received	28

User Statistics

User Activity

Cisco Works LMS 3.2 HA Symantec Software

WAE-512 with inline module

Ace Sticky Configuration

Re: WAE-512 with inline module

Re: Routing between internet and VLANs

Re: PIX MAC Address

Re: ip domain name

Re: multicast problem