I have two cisco switches with 2 GBIC ports each. I want to link them with fiber.I have two ws-g5484 that was gave to me. What else do I need to link these switches?Do I need media converters and if so how many.Thank YouBo Hunter
Network: TMG 192.168.1.1/24 This is the route outThen have the L3 switch hereThen the layer 2 switch here With vlan's 10 - 20 - 100 on it.I only want to route the 10 - 20 vlans, the 100 vlan is a dmz that will go all the way back to TMG.I wan...
Thanks Qiuslar,Ok,So on the 2950 L2 switch do I need to configure a port as a trunk? say port 0/1Then link that port to the port on the 2948-L3 that is configured with the port-channel sub interfaces? say port 1Then on the L3 switch plug the ISA fire...
Thanks Giuslar,Questions inline.giuslar wrote:Hello Bo,for inter vlan routing on L3 switch you need to enable ip routingip routingyou need to define a L3 object named SVI (switched virtual interface) for each vlan that should be part of routed domain...