JamesWhen joining the SPT the router will check once every second and compare the rate received to the threshold rate. By default the threshold rate is 0Kbps. If the received rate is greater than the threshold rate, then the router will set the J f...
In PIM-SM when the first hop router (the one directly connected to a source S) receives the first packet of the multicast stream it will build an (S,G) entry and a parent (*,G) if it does not already exist. If there are no receivers for group G when...
Milan,On a catalyst 6000 running in the hybrid mode, the command is the same as on the cat5000. On a catalyst 6000 running in the integrated IOS mode the command is "sh catalyst6000 chassis-mac-addresses". For the cat4000 supervisor I (WS-X4012) an...
Snitram,The Cat5000 chooses the spanning-tree mac-addresses from the set built into the eprom on the switch chassis. Use the command "show sprom chassis" to show the list of mac-addresses. 5500 (enable) show sprom chassisSerial EEPROM Contents: EEP...