I have a DMZ named DMZ4. The address range is 192.168.31.0/24. The gateway address is 192.168.31.1 I have a host with an IP of 192.168.31.5 that needs access to the internet. I have created a static translation, static (dmz4,outside) xx.xx.xx.136...
I have my ASA in gi7/5 and my monitoring app in gi7/6. I have the following config:monitor session 1 source int gi7/5monitor session 1 dest int gi7/6When I connect the ethernet cable of the monitoring app to gi7/6 traffic to the ASA stops. Cannot g...
I currently am using an IPS application where the inside interface of my ASA is directly connect to the IPS device to allow the monitoring of all traffic entering the ASA.I now have another application that will also need to see all traffic entering ...
I have a 2851 at one site of our 4 site MPLS. At this site I have two T1's from our provider that I have configured as a Multilink. On Sunday one of the circuit had an issue. I was informed by our provider that the LEC had resolved this issue. Now...
Got a question I should know the answer to. I have a 4507R with dual Sup II Plus. I have 5 layer 3 VLANs created. I have a business partner that has VPN access to our LAN. I need to give him access to a server, however, I do not want this server ...
Thanks again for your reply. This issue is resolved. The port I was using for 192.168.31.5 in my DMZ switch was configured for VLAN 30 and not VLAN 31.
Thank you for the reply. Still not working.1) No hits on the ACL.2) I had already issued "clear xlate" after creating the new static translation.3) Configrued no sysopt noproxyarp outside.4) Clear ARP on internet router.I have attached a santiz...
You can look at a security context as a virtual firewall. Each virtual firewall can have it own configuration and is independent from the other virtual firewalls.
Hi Spremkumar,You raise a good point about running them as individual links. I will have to give it a bit of thought as to any constraints we may have. Off the top of my head I cannot think of any.Thanks.Jim
Thanks for the reply Rick. I had tried a shut/no shut and that did not resolve the issue. The provider is still looking into the issue as I told them it is still a circuit issue. Thanks again.Jim
