It doesn't come with CD and manual. Would it be ok I use the instruction below? Do I miss any valuable resource by not having the CD and manual book?http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/intro.html
I have a question about the different between 2 crc errorsADSL circuit has packet loss, when I enter show dsl int atm 0/0/0.The crc Errors and Header Errors are 0.This is good.When I enter show inter atm 0/0/0.The crc value is incrementing when packe...
I believe cold start is the router shut down then power back up.How come the result from show ver said router had been reload instead of power on?==============router1 uptime is 2 days, 16 hours, 55 minutesSystem returned to ROM by reload at 23:30:12...
I entered the following 2 commands, there is no input error on atm 0/0/0, only 92 crc, but there are lot of crc error on sh dsl atm 0/0/0, are these layer 1 or layer 2 error?router#sh int atm 0/0/0ATM0/0/0 is up, line protocol is up Queueing strateg...
What is that header error? I thought it was the layer 2 header.Init FW: init_AMR-R-2.5.042_no_bist.binOperation FW: AMR-R-2.5.042.binFW Source: embeddedFW Version: 2.5.42
Today, telco fixed the problem. They tested LMI is up a few day ago, said it was my equipment, but we escalated the ticket to telco again, they reset the service-module, their equipment was not able to send LMI. My router showed up/down and DTE LMI...
Reliability is 255/255, I always check this number. There are multiple routers have the same issue. Currently, we are tracking it, maybe it is IOS or else.I am just wondering, is there anything else I need to pay attention====================ATM0/0...
no. According to the lab assignment, I didn't select any routing protocol. 1.Select Basic Firewall2.click launch the selected task3.The firewall wizard screen appears4.For the outside interface, select FA0/1 interface5.For the inside interface, sele...
