I am trying to set up ACS to use AD for authentication. I have followed the instructions Cisco gives out, but my test account still fails when I try to log into any network device. I've looked in the ACS logs and it keeps showing "CS user unknown"....

I am having an issue on my 6513 where I can install a QoS policy. I just can't apply the policy to an interfacce. I have tried this a few times, but keep getting the same error.I input this:mls qos map policed-dscp normal-burst 24 26 to 8mls qos m...

Maybe I'm being thick about this. I need to send traffic through a L2L IPSEC tunnel to a remote office location. My issue is this: I need to send a private subnet (10.5.1.0/24) through my L2L tunnel and then NAT that subnet to a public IP. I'm su...

I just installed a 525 at a remote site. I made sure I had a good host name and FQDN in the config. I generated the RSA key pair. SSH statements are there as well allowing access to the inside interface. I was then able to SSH into the box via an...

All the commands are in the new 7.2(2) config:Management-access insideSSH xxx.xxx.xxx.xxx insideI also generated the RSA keyWe try to go through our L2L tunnel and get nothing. Putty just times out. This worked fine as a 6.3(3) box.We're also able ...