also do not forget to add a default route route outside 0 0 10.0.0.20 (if thei is you default route)Note the management ip addresses and the default route must be in the same network .eg from your config 10.0.0.0 networkRegards
the proble with thsi config is you are missing the secondary manangement addressthe command ip address 10.0.0.3 255.255.255.0 should be ip address 10.0.0.3 255.255.255.0 standby 10.0.0.4the 10.0.0.4 will be the failover ip address from the secondary ...
what you need to consider is the link the state link and the failover link.I have one with mpls carrying the link ( riding on static route) but will preffer a bridge if possibel.Make the switch port connected to the lan failover and state link port...
Hi,To introduce the new primary.Switch the new firewall off. Connect the cables to the new pix.Connect the failover cable.The switch it one.The presnt (secondary firewall that is active, with write the config back to the primary).Note: the secondar...